Manual is the default mode.
•Click on an item in the list to display file information.
•Clear the list by clicking on "Reset List" button.
•Process 1 file, via the 
button. it will process highlighted/selected file.
•Process All, via the 
button. It will process all files from the list.
•Use the 
button to stop processing :
Autofill carries out this operation in a loop until an operator clicks on this button.
This stops everything (both the manual and automatic modes).
This window is shown :
Click on 
(Yes) or 
(No)
The file processing when stoping the import will be canceled.
•Play a file. Plays highlighted/selected file (An audio resource must be selected, refer to Setup, "Audio Resource to use" parameter).
To play a file, select it from the list and press 
. Press 
to stop playing.
While playing the sound, you will be shown basic information on the length of the file, levels, and, if the file is linear, a phase correlator.
During the procedure, the file being processed is highlighted (left-hand icon). A progress percentage and the file status are displayed on the right.
NB: Before processing a file, Autofill checks that it is not being updated or saved. If it is, Autofill ignores it and goes on to the next one.
As explained above, in automatic mode, once all the files are processed (or ignored), Autofill goes into standby. When this period is over, it runs a new search in the source directory to find any new files to add to the list, along with any files it ignored before.
Then AutoFill runs its same loop check to see if the previously-ignored files are now ready for processing.
Please note that files with a duration equal to zero are also ignored.