In order to use Snippet in the best possible way, it is necessary to check the settings.
To do this, click on "File" in the menu and then "Setup".
The following window opens:
Section : Audio Board:
Audio Board: Allows you to select the number and name of the board used. "0" for dynamic allocation
Audio Channel: Allows you to enter the channel used. Valid only for multichannel cards.
Section: Sound File Format :
Format: Audio formats supported by the RadioAssist application
•Raw MPEG
•BWF MPEG
•Linear BWF
•Linear WAV
•MP3
Rate: Compression ratio
Frequency: Sampling frequency depending on the format used - from 8 kHz to 48 kHz
Mono/Stereo :
•Mono : Mono recording
•Normal Stereo : Recommended default setting
Record input: Allows you to select inputs for recording.
•Analog line level: Analog line input
•Analog Mic level (PCXPocket Only) : Microphone level input (PcxPocket cards for laptops)
•Analog Stereo Mix : Stereo Mix Input.
•Digital : Digital Input
•Digital AES Sync: Digital input with AES signal
Section: Remote control:
Use Remote Control: Allows to activate the use of a dedicated remote control
List of supported remote controls:
•JL Cooper : CS1 and MCS3
•AR-2000
•Eela Audio-Logos
•D-Cart
•David EdiDesk
•Shuttle Xpress
RS-232 Com port: Fill in the number of the RS-232 communication port.
Section: Effects :
It is possible to use sound effects in Snippet+.
The effects are VST plug-ins.
Enable effect: Enables effects.
VST Folder : Allows you to enter the folder where the effects are located. The "\" must be put at the end of the path.
Section : Snapshot save :
Check the "Enable Snapshot Save" box to activate the automatic save function.
Enable Snapshot save: Enable saving the currently edited edit to the workstation's local disk.
Save frequency (Minutes): Allows you to set the frequency at which the currently edited edit is saved.